SPT SD-2213S Guide d'installation télécharger pdf (Page 12)

Rinse-Aid indicator

Rinse Aid Dispenser

The rinse aid is released during the final rinse to help remove spots and prevent film

build-up on your dishes, flatware and cookware. Also improves drying by allowing water

to sheet off the dishes. Your dishwasher is designed to use liquid rinse aids.

ADDING RINSE AID

The rinse aid dispenser is located inside the door, next to the detergent dispenser.

1. Make sure the dishwasher door is fully open.

2. Turn the dispenser cap counter-clockwise to the left arrow. Lift and remove cap.

3. Add rinse aid until the indicator window turns completely black - be careful not to overfill.

(The capacity of the rinse aid container is approx. 3.7 oz.)

4. Replace cap by aligning to the “open” (left) arrow and turn clockwise to close.

5. Clean up any spilled rinse aid to avoid excessive foaming in the next wash.

REFILLING RINSE AID

When the rinse aid container is full, the Rinse Aid

Indicator (next to the cap) will be dark. As rinse aid

diminishes, the size of the dark dot will also reduce.

Do not let the rinse aid fall below 1/4 full:

Full

3/4 full

1/2 full

1/4 full - time to refill to eliminate spotting

Empty

Attention!

Only use branded rinse aid for the dishwasher. Never fill the rinse aid dispenser with

other substances such as liquid detergent.

ADJUSTING RINSE AID DISPENSER

The rinse aid dispenser has four settings. It is recommended

to start with the dispenser set at “3”. If spots or poor drying

occurs, increase the setting to “4”. If there are sticky

whitish stains on dishes or bluish film on glassware, reduce

the setting to “2” or “1”.

Adjusting lever

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Pas de commentaire

SPT SD-2213S Guide d'installation Page 12